BACK TO WRINGING ANGLE BLOCKS |
||||||||||||||||||||||
ANGLE GAGE BLOCK HEADER PAGE |
||||||||||||||||||||||
Sources of Error When Wringing Angle Blocks |
||||||||||||||||||||||
Consider a 45° angle block with a surface of 1" x 2". |
||||||||||||||||||||||
Angle gage blocks must be wrung with their sides parallel to each other. Else, as seen above, it is impossible to set a true angle. |
||||||||||||||||||||||
It is recommended that the sides of the angle blocks be made parallel by aligning them against a flat surface after wringing them together. |
||||||||||||||||||||||
BACK TO WRINGING ANGLE BLOCKS |
||||||||||||||||||||||
ANGLE GAGE BLOCK HEADER PAGE |
||||||||||||||||||||||
AG26 |
|
|||||||||||||||||||||