PREVIOUS
HEIGHT GAGES AND ACCESSORIES
The "channel design" places additional measuring pads at appropriate points over the length of the bar as reference points for x, y, and z axis measurements. Channel design permits use of the bar on its base (vertical), or, on its back, or either side (horizontal). The alternating gage block jaws and spacer blocks are permanently wrung and fastened together to form 1" increments for inch bars and 25mm increments for metric bars.
A special bushing arrangement allows the master stack to conform to thermal conditions prevailing during use, thus providing a true master even under less than perfect laboratory conditions. Mating surfaces are treated during assembly to prevent corrosion.
Non-standard lengths and mesuring increments are available on special order. A Certificate of Calibration included. All models are furnished with a storage case.
| Description |
Inch System
|
Metric System
|
| Tolerance (Stack) | expressed in µin. | expressed in µm |
| Maximum
Minimum |
2.5L +10 in inches
-10 |
.0025L + .25 in mm.
-.25 |
| Parallelism: Gage surfaces to base and each other | 15 µin. | 0.4 µm |
| Uncertainty of calibration | 10 + 2.0L in inches
expressed in µin. |
.25 + .002L in mm
expressed in µm |
PREVIOUS
WEBBER HOME PAGE
HG1